10mm Radius 30mm x 630mm Worktop End Cap Satin Silver

R-10mm x 28mm-30mm x 630mm Worktop End Satin Silver

This metal worktop end cover trim from Design Hardware features an anodised aluminium satin silver finish that coordinates with many kitchens. This end trim reduces time and simplifies installation and covers exposed breakfast bar ends, providing a durable alternative to laminate edging.

Worktop end trims are flat aluminium plates that cover the end of a worktop run, they feature a curved top lip that sits on the top surface of the worktop approximately 2mm high covering any chipped edges within 5mm of the worktop edge. Each end of the trims are profile matched to the worktop so they will fit either a left or right hand installation.

This worktop end trim will suit 28mm - 30mm thick worktops that feature a waterfall profile with a 10mm radius to the top and square bottom edge profile. Install using silicone to seal any raw worktop edges to prevent water ingress, and secure the trim in place with countersunk wood screws. This cover trim will suit worktops up to 616mm deep, for deeper worktops our breakfast bar trims can be used in the same way.

This metal end trim is suited to the following 28mm-30mm worktops:
• Euro profile.
• Waterfall profile.
• Kronospan 28mm waterfall profile.
• Oasis 28mm waterfall profile.
• Odyssey 28mm worktop profile.

This satin silver worktop edging is supplied in single units without screws.